![]() ![]() There is no issue with using glue guns, soldering, or any other hassle. Now This Is Up To You!ĭouble Sided tape is your best buddy if you are working with LED light strips. Pick a spot that isn’t too hot since the heat may degrade the adhesive property of the tape. ![]() Choose the strongest double sided tape in the market and adhere it to the LED strip and the surface with caution. To make sure your LED light strips stick, clean the surface with a 50-50 solution of isopropyl alcohol and water to eliminate even a speck of dust. After you have attached one side of the tape to the strip, carefully adhere the other side to the surface. Be mindful of the size of the tape and make sure it matches the width of the strip. Peel off the protective cover from the LED strip and adhere to the double sided tape with the strip carefully. Here are a few things you can do to avoid this issue: If the surface is dusty, even the strong double sided tape won’t stick. However, you must not forget to prepare the surface before putting up the strip or the tape. Installing LED light strips is pretty exciting, and we often cannot wait to see them glow. How to Set Up LED Light Strips on a Flat Surface Once you have made up your mind, adhere the double sided tape to the surface. You could also try it out with the adhesive of the LED strip since it is not that strong to check out your ideas in real life. That is why we suggest doing a few mock-ups or trial runs with scotch tapes to see if you are really sure about how you want to put up your lights. Once a strong double sided tape is set on a surface, it becomes difficult to perform modifications. ![]() Then, the double sided tape needs to adhere to that portion, and leave it on so that you can adhere it to your desired surface later. Thus far, it has remained firmly in place, and the lights have not gone out.Step 4: Adhere to the LED Strip with CautionĪfter you have sliced up the tape, take off the protector portion away and bring out the adhesive part of the LED strip. It was simple to use and apply to the back of the lights and the wall. I had previously purchased LCD lights with adhesive on one side, but they would not stick to my wall and kept falling, so I bought this to stick them back on. It was perfect for my LCD lights on the wall.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |